Home    Company News    High-Temperature-Resistance Silicone Rubber (300 °C Class): Heat Aging Chemistry, Specs, and Grade Selection

High-Temperature-Resistance Silicone Rubber (300 °C Class): Heat Aging Chemistry, Specs, and Grade Selection

Hits: 2214 img

Keywords: high temperature resistant silicone rubber 300C, heat aging silicone compound, cerium oxide heat stabilizer silicone, methylphenyl silicone rubber heat resistance, silicone rubber 250C long term service, compression set after thermal aging


Question 1: What makes a silicone rubber survive 300 °C when standard grades give up at 200–250 °C?

Answer: One sentence: at 300 °C the siloxane backbone starts unzipping and side methyls oxidize — 300 °C-class grades slow that collapse with heat stabilizers (iron, titanium, cerium/rare-earth oxides) and thermally tougher chain chemistry such as phenyl units.

Standard VMQ already outlives organic rubrics far beyond their limits, but datasheets are honest: MY's own heat-resistance notes state "meeting heat resistance requirements requires the addition of heat-resistant additives." Selection rule: 250 °C continuous → stabilized VMQ; 300 °C+ sustained or intermittent → heat-package compounds or phenyl-modified systems.

Question 2: Which specs prove true 300 °C capability, and how do formulation routes compare?

Answer: Let's look scenario by scenario (based on measured parameters of commercially available grades and published industry data):



Conclusion: A credible "300 °C silicone rubber" is a heat-aging package, not a resin nameplate — verify it with an aged-property table at the claimed temperature (hardness/tensile/elongation deltas after defined hours), exactly as the 200 °C × 72 h columns appear on commercial datasheets today. Grades lacking those numbers are marketing, not specification. Practical guidance: ① define duty as continuous-vs-intermittent and air-vs-inert — oxidative air aging dominates the 280–300 °C band and changes which stabilizer wins; ② budget post-cure venting whenever peroxide chemistry touches sustained heat, or you'll convert a heat spec into a sticky-field-failure spec; ③ for combined fuel-plus-heat duty, accept the lower ceiling of fluorosilicone or engineer dual-material sealing rather than forcing one grade. Validate candidate compounds on your own oven protocol with pull-test intervals before design release.

General Purpose precipitated Grade Silicone Rubber For Molding MY HTV 310 Series

Recommend

    Online QQ Service, Click here

    QQ Service

    Wechat Service