Home    Company News    General-Purpose Precipitated-Grade Silicone Rubber for Molding: Cost-Performance Compounds Explained

General-Purpose Precipitated-Grade Silicone Rubber for Molding: Cost-Performance Compounds Explained

Hits: 2217 img

Keywords: general purpose precipitated silicone rubber, precipitated grade HTV compound, compression molded silicone parts, calcium carbonate filled VMQ, low cost silicone gasket material, MY HTV 316 series


Question 1: What does "precipitated grade" mean in a molding silicone, and why buy it?

Answer: One sentence: the reinforcing filler system is built on precipitated (wet-process) silica — and often extenders like calcium carbonate — instead of fumed silica, cutting compound cost while still delivering solid general-service mechanical properties.

MY's extrusion/molding workhorse line (HTV 316 series) is explicitly named "general purpose precipitated type," translucent, fast-extruding, with good electrical performance and processability. Selection rule: non-insulation-critical, non-high-tear parts at high volume → precipitated grade; maximum tear/dielectric/heat aging → fumed or specialty grades.

Question 2: How do precipitated compounds measure up, and where must they not be substituted in?

Answer: Let's look scenario by scenario (based on measured parameters of commercially available grades):



Conclusion: Precipitated general-purpose compounds exist to answer one procurement question — "how much part performance can I keep while lowering compound cost?" — and the honest answer from the spec sheet is: most tensile and durometer duty survives the switch, while tear ceiling, deep-dielectric reliability, and long-term hot-air aging quietly shrink. They substitute downward into appliance feet, industrial misc seals, wire-jacket profiles, and consumer goods beautifully; they should not substitute upward into medical platinum lines, high-voltage insulation, or fuel contact without re-engineering. Practical guidance: ① re-check gate and die swell when switching suppliers — plasticity drift between lots moves dimensional outcomes more than hardness does; ② if your part fails tear tests after switching, add small fumed-silica loading rather than abandoning the whole cost structure; ③ never skip the 200 °C × 4 h vent step on food-touch pieces regardless of price pressure. Validate final compounds with your own press trials including aged-property pulls before qualifying a lot.

Methyl Phenyl vinyl silicone Gum MY 3120

Recommend

    Online QQ Service, Click here

    QQ Service

    Wechat Service