Home    Company News    Thermally Conductive Silicone Rubber: W/(m·K) Ratings, Filler Trade-offs, and Potting Guide

Thermally Conductive Silicone Rubber: W/(m·K) Ratings, Filler Trade-offs, and Potting Guide

Hits: 2216 img

Keywords: thermally conductive silicone rubber, thermal conductivity potting compound, 0.7 W/mK silicone, power electronics heat dissipation, UL94 V0 flame retardant potting, MY LSR 3760


Question 1: How can silicone — a natural insulator — become a heat path?

Answer: One sentence: the elastomer matrix stays the same while dense ceramic fillers (alumina, boron nitride, etc.) build particle-to-particle conduction chains — turning a soft seal into a controlled heat-transfer layer rated in W/(m·K).

Standard VMQ conducts almost nothing; MY's thermal-conductive line proves the shift quantitatively — 0.7 W/(m·K) measured on MY LSR 3760 while keeping full rubber compliance. Selection rule: you must move heat through a flexible or potted interface → conductive grade; you must block heat or current only → standard grades.

Question 2: What specs define a workable thermally conductive silicone, and what processing limits follow from them?

Answer: Let's look scenario by scenario (based on measured parameters of commercially available grades):



Conclusion: Thermally conductive silicone is specified by a three-number triangle — W/(m·K), dielectric integrity, and durometer-vs-elongation cost — and every gain on one axis moves another, so target the actual heat-flux path rather than chasing maximum conductivity. Substitution logic: standard LSRLs cannot replace it wherever interface temperature rise drives failure rates; conversely paying for conductive filler in non-heat-critical parts adds cost and kills flexibility pointlessly. Practical guidance: ① verify conductivity reports cite a recognized method (GB/T 10297 or ISO 22007 family) — uncontrolled comparisons vary widely; ② design pour/degas around the 2 h working window and cure-by-thickness tables, since thick sections self-insulate exotherm-free addition systems differently than thin films; ③ treat settling as a process parameter: log stir energy per drum and re-check density drift incoming. Validate with junction-temperature measurements in your real assembly before qualification.

Fluoro Silicone Gum (MY 3110-F series)

Recommend

    Online QQ Service, Click here

    QQ Service

    Wechat Service