Home    Company News    Vinyl-Terminated Fluorosilicone Liquid Rubber (FLSR): Fuel-Resistant Injection Molding Guide

Vinyl-Terminated Fluorosilicone Liquid Rubber (FLSR): Fuel-Resistant Injection Molding Guide

Hits: 2229 img

Keywords: vinyl fluorosilicone liquid rubber, addition cure FVMQ LSR, fuel resistant liquid silicone, platinum cured fluorosilicone, jet fuel sealing parts, MY FLSR 3400 series

Question 1: Why build vinyl into a fluorosilicone liquid rubber?

Answer: One sentence: vinyl end/side groups give the trifluoropropyl-siloxane chains reactive sites for platinum addition cure — converting oil-resistant fluorosilicone chemistry into a fast-molding two-component liquid rubber.

MY FLSR 3400 series pairs ethylene-containing polyfluorosiloxane base gum with Si–H fluorosiloxane crosslinker under platinum catalysis, filling reinforced with fillers — delivering high/low-temperature stability, oil resistance, and electrical insulation in short processing cycles. Selection rule: fuel/lubricant contact plus sub-zero flex on an LSR press → this class; hot-oil-only duty → FKM remains cheaper per seal-life year.

Question 2: Which measured specs prove it works, and how should a line process it?



Conclusion: Vinyl fluorosilicone liquid rubber is specified when the medium and the temperature fight simultaneously and the shop runs injection molding — its datasheets read like a fuel-pump inventory because nothing else in the silicone catalog survives that list while staying flexible at −50 °C-class service. It cannot substitute downward into cost-driven hot-air gaskets, nor upward into continuous strong-aromatic immersion (Fuel C/FAM B numbers mark the ceiling). Practical guidance: ① test your actual fuel blend, not ASTM proxies alone — methanol and biodiesel fractions behave very differently; ② treat the 200 °C post-cure as part of the specification since skipping it nearly triples compression set; ③ enforce platinum-clean segregation harder than for methyl LSR given shared workshops often handle amine chemistries. Validate burst pressure, swelling pull-tests, and cold rebound on production samples before qualification.

Low compression set precipitated silicone rubber MY HTV 333 series

Recommend

    Online QQ Service, Click here

    QQ Service

    Wechat Service