Hits: 2223 img
Keywords: polysilazane coating, silazane ceramic precursor, SiCN conversion coating, high temperature protective coating binder, MY 9150 PR214 equivalent, solvent-free polysilazane resin
Answer: One sentence: MY 9150 is a Si–N backbone liquid precursor that converts into an amorphous SiCN/SiOC ceramic phase on curing — a polymer you can coat or bond with, that ends up behaving like ceramic.
Unlike silicone resins whose Si–O chains degrade organically above ~300 °C, polysilazane networks rearrange into dense non-crystalline ceramics, which is why the family sits at the top of MY's heat-resistance ladder (the related silazane adhesive/sealant grades are rated 800–1000 °C service). Sourced as equivalents of 718-Institute PR214/PR21-class material and Chinese Academy of Sciences grade 105. Selection rule: you need a processable liquid that becomes heat/corrosion/ablation armor → silazane; ordinary weatherproof hardness → silicone resin suffices.
Answer: Let's look scenario by scenario (based on verified catalog data; full TDS parameters to be confirmed by technical department):
Conclusion: MY 9150 is chosen when the requirement reads "coatable now, ceramic later" — corrosion barriers under incandescent cycling, abradable seal coatings, high-heat bonding where organic binders char away — performance space no conventional silicone resin occupies. It should not displace cheaper methylphenyl or epoxy-modified silicones below ~300 °C, where their weathering and cost profiles win outright. Practical guidance: ① qualify on your cure profile first: room-temp schedules trade conversion depth for convenience, so match grade choice (RT vs. 170 °C series logic) to the actual service temperature margin; ② control humidity during application and flash-off more strictly than with alkoxysilane coatings — uncontrolled moisture reaction causes pinholes and blushing; ③ run adhesion pulls after thermal cycling, not just ambient, since ceramic conversion changes shrinkage stress. Request current TDS/COA for MY 9150, 9150K, and 9150A from our technical team to complete your specification package before pilot trials.
Addition liquid silicone rubber for copper plate printing MY 3M35